Friday, October 7, 2011

Hay Manger Design Improvements

My brother said it was a pain to make the manger the way he did the first one with the routed out 2X4 so this time we pre-bent the section of panel by screwing one end of a 2X4 to a barn post at floor level with the panel under it. We maneuvered the panel until we had the "bend line" where we wanted it under the 2X4 and then I stood on that (my participation) while he bent the panel for the side bend. We repeated it on the other side and then used large barbed fence staples to attach it to the 2X6 wall. You can see the photos attached.

No comments:

Post a Comment